Markbass R 500 Manuel d'utilisateur télécharger pdf (Page 7)

3.2 R500 REAR PANEL

15 16 17

19 20 21

PRE EQ

POST EQ

SPEAKER OUT

The R500 can be connected to one or two speaker cabinets using either 1/4” speaker cables (do not use instrument cables) or speakon speaker cables. The two high-quality

Neutrik SPEAKON COMBO jacks (15,16) are designed to accept either of these connection types. The minimum load is 4 ohms. If you connect two cabinets, the impedance

of each cab must be 8 ohms or higher. If you connect a 4 ohm cabinet, you cannot connect a second cabinet. The R500 delivers 300W of power into an 8 ohm cabinet, or

500W into a 4 ohm cabinet.

LINE OUT

The balanced XLR (21) output allows you to connect your amplifier directly to a mixing console (either in live situations or in a recording studio) without the need of a DI box.

Simply connect a standard XLR cable from this output to the soundboard/mixing console, or a snake connected to the board/console. If the soundman/engineer needs more

or less signal from you, simply turn the front panel LINE OUT (9) control up or down as necessary.

PRE EQ / POST EQ

This SWITCH (17) determines whether the signal that leaves the LINE OUT XLR (21) is affected by your amplifier’s EQ settings or not. In most cases, you will find that sound

engineers prefer to receive a pre-EQ signal. Note that the line out signal includes whatever effects you’ve connected through the effects loop.

GROUND LIFT

Occasionally when you’re playing live and using the LINE OUT (21), the soundman will detect a hum from your amp’s signal. This is almost always due to a grounding problem

related to your power source; you will likely eliminate this hum simply by flipping the GROUND LIFT (22) switch.

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Markbass R 500 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Markbass R 500